Triconex 3805E模拟输出模块
Manufacturer : Triconex
Product No. : 3805E
Product type : Analog Output Modules
Type : TMR
Output current range : 4-20 mA output (+6% overrange)
Number of output points : 8
Isolated points : No, commoned return, DC coupled
Resolution : 12 bits
Output Accuracy : <0.25% (in range of 4-20 mA) of FSR (0-21.2 mA), from 32° to 140° F (0° to 60° C)
Over-range protection : +42.5 VDC, continuous
Switch time on leg failure : < 10 ms, typical
Color code : Pea Green
Weight : 4 kg
Dimension : 9 kg
Shipping weight : 10 kg
制造商:Triconex
产品: 3805E
产品类型:模拟输出模块
输出电流范围:4-20 mA输出(+6%超量程)
输出点数:8
隔离点:不，共返回，直流耦合
分辨率:12位
输出精度:FSR (0-21.2 mA)的<0.25%(在4-20 mA范围内)，从32°到140°F(0°到60°C)
超量程保护:+42.5 VDC，连续
开关时间腿故障:< 10毫秒，典型
颜色代号:豌豆绿
重量:4公斤
尺寸:9kg
运输重量:10公斤
The TRICONEX safety control system is the most advanced fault-tolerant controller based on the Triple Module Redundancy (TMR) architecture. TMR is a three-way isolated, parallel-operated control system and performs extensive diagnostics in each independent control system. The system uses a three-way logical vote to provide a highly perfect, error-free, uninterrupted process operation, not because of a single point of failure caused by system failure.
TRICONEX安全控制系统是基于三模块冗余(TMR)架构的最先进的容错控制器。TMR是一个三向隔离、并行操作的控制系统，在每个独立的控制系统中执行广泛的诊断。系统采用三向逻辑投票，提供高度完善、无错误、不间断的流程操作，不会因为单点故障而导致系统故障。
The MP controller uses three independent channels, each of which is executed independently of the other two channels in parallel. All digital input / output signals from the field are voted on by a patented hardware voting device, while the analog signal is Intermediate value selection processing. Because each channel is isolated from other channels, any channel single point failure does not affect other channels. If a channel has a hardware failure, and the other channels do not care about it. During this period, the controller can be easily plugged and replaced with the faulty module without interruption.
MP控制器使用三个独立的通道，每个通道独立于其他两个通道并行执行。所有来自现场的数字输入/输出信号都通过专利硬件投票装置进行投票，而模拟信号则进行中间值选择处理。因为每个通道都与其他通道隔离，任何通道单点故障都不会影响其他通道。如果一个通道有硬件故障，而其他通道不关心它。在此期间，可以方便地插拔控制器，更换故障模块，不中断业务。
