描述
PLC外部驱动电路对于PLC输出不能直接带动负载的情况下，必须在外部采用驱动电路：可以用三极管驱，也可以用固态继电器或晶闸管电路驱动，同时应采用保护电路和浪涌吸收电路，且每路有显示二极管（LED）指示。印制板应做成插拔式
National Instruments AT-MIO-16DE-10 card
NATIONAL INSTRUMENTS SCXI-1121 MODULE 4 CHANNEL AMP
NI National Instruments Camera Link PCI 1428 IMAQ Card
National Instruments: ER-8 with CB-50LP I/O Connector
National Instruments (NI) PXI-6071E multifunction I/O
LOT NATIONAL INSTRUMENTS COMBO SOFTWARE DAQMX PXI SCXI
National Instruments NI FP-AI-102 8Ch High Volt Analog
VHDCI Breakout for National Instruments NI “M”seies NEW
NATIONAL INSTRUMENTS PCI-232/485 ISOLATED 4-CHANNEL DAQ
